Re: Template file for DSPFD

As always, there's a TAA Tool.  See:

http://www.taatool.com/document/L_dspoutfile.htm

Al

Al Barsa, Jr.
Barsa Consulting Group, LLC

400>390

"i" comes before "p", "x" and "z"
e gads

Our system's had more names than Elizabeth Taylor!

914-251-1234
914-251-9406 fax

http://www.barsaconsulting.com
http://www.taatool.com
http://www.as400connection.com



                                                                           
             Vernon Hamberg                                                
             <vhamberg@comcast                                             
             .net>                                                      To 
             Sent by:                  Midrange Systems Technical          
             midrange-l-bounce         Discussion                          
             s+barsa=barsacons         <midrange-l@xxxxxxxxxxxx>           
             ulting.com@midran                                          cc 
             ge.com                                                        
                                                                   Subject 
                                       Re: Template file for DSPFD         
             10/12/2005 03:39                                              
             AM                                                            
                                                                           
                                                                           
             Please respond to                                             
             Midrange Systems                                              
                 Technical                                                 
                Discussion                                                 
             <midrange-l@midra                                             
                 nge.com>                                                  
                                                                           
                                                                           




F1 is your friend!   Make that into a poster and put it up in your cubicle.

Every OUTFILE parameter I've seen has the formats listed in the help
for the parameter. So type DSPFD, press F4, press F9 or type *OUTFILE
for the OUTPUT parameter and press Enter. Put your cursor on the
parameter and press Enter.

Or shortcut the above by typing DSPFD and pressing F1 - works on most
command lines, not on some. Then dig down to the OUTFILE section.

In this case there is a nice table of all the outfile formats.

Enjoy! Get acquainted with your new friend!

HTH
Vern

At 03:57 PM 10/11/2005, you wrote:

>anybody know if there is a template file that i5 uses to create the
>outfile of the following command?
>
>DSPFD FILE(MYFILE) TYPE(*MBRLIST) OUTPUT(*OUTFILE) OUTFILE(MY/TEST)
>
>--
>This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing
list
>To post a message email: MIDRANGE-L@xxxxxxxxxxxx
>To subscribe, unsubscribe, or change list options,
>visit: http://lists.midrange.com/mailman/listinfo/midrange-l
>or email: MIDRANGE-L-request@xxxxxxxxxxxx
>Before posting, please take a moment to review the archives
>at http://archive.midrange.com/midrange-l.

--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.