Re: Template file for DSPFD

great..

On 10/12/05, Vernon Hamberg <vhamberg@xxxxxxxxxxx> wrote:
>
> F1 is your friend! Make that into a poster and put it up in your cubicle.
>
> Every OUTFILE parameter I've seen has the formats listed in the help
> for the parameter. So type DSPFD, press F4, press F9 or type *OUTFILE
> for the OUTPUT parameter and press Enter. Put your cursor on the
> parameter and press Enter.
>
> Or shortcut the above by typing DSPFD and pressing F1 - works on most
> command lines, not on some. Then dig down to the OUTFILE section.
>
> In this case there is a nice table of all the outfile formats.
>
> Enjoy! Get acquainted with your new friend!
>
> HTH
> Vern
>
> At 03:57 PM 10/11/2005, you wrote:
>
> >anybody know if there is a template file that i5 uses to create the
> >outfile of the following command?
> >
> >DSPFD FILE(MYFILE) TYPE(*MBRLIST) OUTPUT(*OUTFILE) OUTFILE(MY/TEST)
> >
> >--
> >This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing
> list
> >To post a message email: MIDRANGE-L@xxxxxxxxxxxx
> >To subscribe, unsubscribe, or change list options,
> >visit: http://lists.midrange.com/mailman/listinfo/midrange-l
> >or email: MIDRANGE-L-request@xxxxxxxxxxxx
> >Before posting, please take a moment to review the archives
> >at http://archive.midrange.com/midrange-l.
>
> --
> This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing
> list
> To post a message email: MIDRANGE-L@xxxxxxxxxxxx
> To subscribe, unsubscribe, or change list options,
> visit: http://lists.midrange.com/mailman/listinfo/midrange-l
> or email: MIDRANGE-L-request@xxxxxxxxxxxx
> Before posting, please take a moment to review the archives
> at http://archive.midrange.com/midrange-l.
>
>


--
Best Regards,
Liao Xu