RE: Spool File Stuck in WTR Status -- MIDRANGE-L

× The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.

You may also need to run the QSPFIXUP program (CALL QSPFIXUP), no
parameters. Warning if you have a lot of spools on your system, this command
will take a while to complete.

Loyd Goodbar
Senior programmer/analyst
BorgWarner
E/TS Water Valley
662-473-5713
-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Robert Dobrowolski
Sent: Monday, July 25, 2005 14:20
To: Midrange Mail List (E-mail)
Subject: Spool File Stuck in WTR Status

We have a local twinax attached printer with a spool file entry whose status
is stuck at WTR.  The power was cut to the printer while this spool file was
being printed.  We need to finish printing the file but all of our attempts
have failed.  I have help the file, held the OUTQ, and varied off the
printer.  Unfortunately, when I vary on the printer, restart the writer,
release the OUTQ, and release the spool file, it returns to WTR status, but
nothing prints.  This is on an 810 at V5R2.  Any ideas?

Thanks,
--
Bob Dobrowolski

This mailing list archive is Copyright 1997-2025 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].

Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.