Re: Couldn't start SNTP client on V5R3 270 DSD machine ?

Thanks a lot.

Best regards,

Vengoal

Wayne McAlpine wrote:

It should be supported on the Model 270. The Memo to Users for V5R3 includes the following note on SNTP. Check to be sure that the data area is not on your system.

"3.11 SNTP client changes the system clock instead of the software clock

In V5R3, the SNTP client changes the system clock instead of the
software clock. If you want to have the software clock changed, or if
you install V5R3 on a server that does not support system clock
adjustment (iSeries models 7xx, 170, and 250), you must create a data
area (*DTAARA) object named QTOTSNTP. Use the following CL command to
create this data area object:

CRTDTAARA DTAARA(QUSRSYS/QTOTSNTP) TYPE(*CHAR) LEN(9) VALUE(*SOFTWARE) A
UT(*USE)

To switch back to having the SNTP client change the system clock, run
the following CL command to delete the data area object:

DLTDTAARA DTAARA(QUSRSYS/QTOTSNTP)"




Vengoal Chang wrote:

Hi all ,
   I want use SNTP on iSereies V5R3, I set the SNTP time server with

CHGNTPA RMTSYS('132.163.4.102'), then STRTCPSVR SERVER(*NTP) NTPSRV(*CLIENT), then I got following message:

Additional Message Information Message ID . . . . . . : TCP9155 Severity . . . . . . . : 40 Message type . . . . . : Diagnostic Date sent . . . . . . : 06/29/05 Time sent . . . . . . : 16:48:39 Message . . . . : System clock adjustment is not supported. Cause . . . . . : This iSeries system does not support system clock adjustment. Recovery . . . : Refer to the iSeries Information Center to find out what models support system clock adjustment. It is at http://www.ibm.com/eserver/iseries/infocenter. I saw the V5R3 Information related SNTP, but no document related which iSeries model support system clock adjustment. My iSeries is 270 DSD model .

Any response appreciated.

Best regards,

Vengoal