Re: QCAIEXIT, QMHRTMSS vs QMHRCVPM

[Simon Coulter <shc@xxxxxxxxxxxxxxxxx>]

On 25/02/2005, at 5:56 AM, rob@xxxxxxxxx wrote:

> This line of RPG
>  qmhrcvpm(rcvm0200:%len(rcvm0200):'RCVM0200':'*':StackCnt:'*PRV':
>                     MsgKey:0:'*SAME':ERRC0100);
> is generating:
> MCH1001-Attempt to use permanent system object QCAIEXIT without
> authority.
> MCH1001-Attempt to use permanent system object QMHRTMSS without
> authority.

Are you sure you're interpreting this correctly? I mean are you 
positive this line of code causes the problem? The reason I ask is 
because the MCH1001 messages are sent to the QQDAPROC program rather 
than a message handler (QMH*) program or your program.

> Both have the identical:
> From program . . . . . . . . . :   #auexcpt
>   Instruction  . . . . . . . . :     000B80
>
> To program . . . . . . . . . . :   QQDAPROC
>   To library . . . . . . . . . :     QSYS
>   Instruction  . . . . . . . . :     05E4

QQDA* stuff is something to do with a system debugger judging by the 
messages in QSYS/QQDAMSGF. Are you debugging the program? Perhaps that 
is the root cause?

However, as Bruce said changing the authority on the internal programs 
(i.e., QCAIEXIT and QMHRTMSS) is not the correct solution.

Note that QCAIEXIT is part of the command analyser component.

Regards,
Simon Coulter.
--------------------------------------------------------------------
   FlyByNight Software         AS/400 Technical Specialists

   http://www.flybynight.com.au/
   Phone: +61 3 9419 0175   Mobile: +61 0411 091 400        /"\
   Fax:   +61 3 9419 0175                                   \ /
                                                             X
                 ASCII Ribbon campaign against HTML E-Mail  / \
--------------------------------------------------------------------