Re: How do I debug a Trigger program?

[rob@xxxxxxxxx]

Technically, if you trigger the program from an interactive job, the 
trigger should run in that same job.  If you trigger the program from some 
C/S job then simply do a WRKOBJLCK MYUSRID *USRPRF to find the name of 
that C/S job and service that.
Triggers are not spawned off into another job, (unless your trigger does 
it's own SBMJOB).

Rob Berendt
-- 
Group Dekko Services, LLC
Dept 01.073
PO Box 2000
Dock 108
6928N 400E
Kendallville, IN 46755
http://www.dekko.com





GKern@xxxxxxxxxxxxxxxx 
Sent by: midrange-l-bounces@xxxxxxxxxxxx
01/29/2004 09:10 AM
Please respond to
Midrange Systems Technical Discussion <midrange-l@xxxxxxxxxxxx>


To
midrange-l@xxxxxxxxxxxx
cc

Fax to

Subject
How do I debug a Trigger program?






How does one go about debugging a trigger program?

Since the trigger is at the DB level, it's not and interactive or batch 
job.
 
Is it similar to debugging a batch job where you must start a service job? 

Or is there another method to do step by step debugging of the trigger 
program?

Regards,

Gerald Kern
IBM Certified AS/400 RPG IV Developer & RPG IV Programmer
MIS Project Leader, Lotus Notes/Domino Administrator
The Toledo Clinic, Inc.
4235 Secor Road
Toledo, OH 43623-4299
Phone 419-479-5535
gkern@xxxxxxxxxxxxxxxx
_______________________________________________
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing 
list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.