Re: Cannot RCVMSG a SQL0204 *DIAG message

[jmoreno@xxxxxxxxxxxxxxxx]

I remember having come across a similar problem.

I ended up displaying the contents of the joblog to a spooled file, copying
the spooled file to a database  file and
reading that database file.

Processing all of the messages from the joblog could become cumbersome if
you have a busy job/joblog.

You can send a message to the *EXT message queue prior to your request that
identifies the beginning of processing
and do the same to indicate end of processing (I used custom message
identifiers)

When I was reading the database file I was deliberately looking for those
identifiers.

I knew that the messages I was looking for were found between those two
identifiers.

I hope this helps.



Jorge Moreno
Overseas Military Car Sales
Woodbury, New York


----------------------------------

Disclaimer - This email, including its attachments, may contain information
that is confidential and may be protected by federal and/or state laws and
regulations, or other confidentiality privileges.  This email, including
its attachments, may contain non-public information; therefore it is
intended to be conveyed only to the designated recipient(s).  If you are
not an intended recipient, please delete this email, including its
attachments, and notify the sender.  The unauthorized use, dissemination,
distribution or reproduction of this email, including its attachments, is
prohibited and may be unlawful.

----------------------------------