Re: Restore 21 to a new Iseries

[Jeffry Kennedy <jkennedy@xxxxxxxxxxxxx>]

We also switched from an 820 to 810, no Op's Console on the 810. Both were at
V5R2 and we changed the device description on the 810 to match our definitions.

oliver.wenzel@xxxxxxxxxxxxxxxxxxxxxxx wrote:

> Hi Jan,
>
> >Soon is our S30 scrap iron.
> >We have got a new 810 now. :-)
> >Could someone point to any document how to run a restore 21 to a new
> >Iseries ?
> >Or suggest any recomendation ?
>
> We just switched from our 820 to our new 810 (basically a scratch reload).
>
> As the hardware will not be the same, you'll have to check your device
> descriptions
> and connect them to the right controllers.
>
> Do you have a twinax or OpsConsole? Make sure the Opsconsole is on the
> correct release
> version. Also, be prepared to fight with OpsConsole cabling!
>
> Whe we did the V5R2 upgrade of our 820, suddenly it wanted the OpsConsole
> cable in another
> slot!
>
> What release is your S30? It would be best if its the same as on the new
> 810.
>
> Regards,
>
> Oliver
> _______________________________________________
> This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
> To post a message email: MIDRANGE-L@xxxxxxxxxxxx
> To subscribe, unsubscribe, or change list options,
> visit: http://lists.midrange.com/mailman/listinfo/midrange-l
> or email: MIDRANGE-L-request@xxxxxxxxxxxx
> Before posting, please take a moment to review the archives
> at http://archive.midrange.com/midrange-l.