AW: Socket Programming and Sendind *DTAQ entries

[Werner Noll <werner.noll@xxxxxxxxx>]

Jorge,

if the systems are connected by SNA, the easiest way is to use DTAQs from
TYPE=*DDM. Then you can specify the remote location and you don't have to
care about data transmission. If not, you can probably use the
Anynet-Support and configure SNA over IP.
It's just an idea for a different way.

Regards,
Werner Noll

-----Ursprüngliche Nachricht-----
Von: jmoreno@xxxxxxxxxxxxxxxx [mailto:jmoreno@xxxxxxxxxxxxxxxx]
Gesendet: Mittwoch, 10. Dezember 2003 15:51
An: Midrange-L@xxxxxxxxxxxx
Betreff: Socket Programming and Sendind *DTAQ entries






Hello all,

Does anybody have sample code to do a "Sockets Connection" from an AS400 to
another AS400
and simply having *DTAQ entries flowing to the target AS400.

Is there any shorcuts to the learning curve ?

Thanks in advance


Jorge Moreno
Systems Analyst
Overseas Military Car Sales
Woodbury, New York

Disclaimer - This email, including its attachments, may contain information
that is confidential and may be protected by federal and/or state laws and
regulations, or other confidentiality privileges.  This email, including
its attachments, may contain non-public information; therefore it is
intended to be conveyed only to the designated recipient(s).  If you are
not an intended recipient, please delete this email, including its
attachments, and notify the sender.  The unauthorized use, dissemination,
distribution or reproduction of this email, including its attachments, is
prohibited and may be unlawful.

_______________________________________________
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.