RE: Copier printing

Thanks Simon and everyone else for the replies.  Between your input and
doing a little reading from the Workstation Customization Programming
manual I've decided that I'm just a grain of sand on the beach of printer
options.  What's really amazing is that I took what you (Simon) had said,
combined it with a little that I had read in the WCP manual, AND IT WORKED
THE FIRST TIME!!!  Well, almost...  I can now change the default to drawer
2 and could probably do it for drawer 3 if I had the correct codes and I've
sent an e-mail to the "copier guy" to see if I can get those.  I might also
be able to turn up something with a Web search.

I just added the following to the retrieved source, did a CRTWSCST, and
presto!

:DWRNBR
VAROFFSET = 0
VARLEN = 0
VARTYPE = CHRHEX
DATA = ASCII control sequence from the retrieved source.

Thanks.  You guys rock!

Dave

Dave Parnin
Nishikawa Standard Company
Topeka, IN  46571
daparnin@xxxxxxxxxxxxxxxxxx





                                                                                
                              
                      Simon Coulter                                             
                              
                      <shc@xxxxxxxxxxxx        To:       Midrange Systems 
Technical Discussion                
                      om.au>                    
<midrange-l@xxxxxxxxxxxx>@SMTP@xxx                            
                                               cc:                              
                              
                      06/30/2003 06:34         Subject:  RE: Copier printing    
                              
                      PM                                                        
                              
                      Please respond to                                         
                              
                      Midrange Systems                                          
                              
                      Technical                                                 
                              
                      Discussion                                                
                              
                      <midrange-l@xxxxx                                         
                              
                      nge.com>                                                  
                              
                                                                                
                              
                                                                                
                              




Hello David,

You will have to find out the PCL incantations that select the paper trays.
This
may be the same as standard HP but is often different. Once you have that
information then retrieve the source for the *HP6 WSCST object (presuming
the
'copier service guy' is correct). Then edit that source and locate the
:DRAWER
tag and change the incantation for drawer 1 to be whatever selects the bulk
paper tray. Save the source, compile it using the CRTWSCST command, and
specify
the new WSCST object on the WSCST keyword of the definition.

Since specifying drawer 3 on the spooled file selects the correct drawer
you
could simply swap the incantations for drawers 1 and 3 in the WSCST source.

If the printer supports SNMP or PJL (commonly called port9100 support) then
you
will get better control by defining it as a *LAN printer rather than as a
remoute output queue.

Regards,
Simon Coulter.
--------------------------------------------------------------------
   FlyByNight Software         AS/400 Technical Specialists

   http://www.flybynight.com.au/
   Phone: +61 3 9419 0175   Mobile: +61 0411 091 400        /"\
   Fax:   +61 3 9419 0175   mailto: shc@xxxxxxxxxxxxxxxxx   \ /
                                                             X
                 ASCII Ribbon campaign against HTML E-Mail  / \
--------------------------------------------------------------------

_______________________________________________
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.