Re: Change pf38-dta to pf-dta

["David Dunfield" <ddunfie@xxxxxxxxxxxx>]

Make sure the source file does not use PF38 syntax for field references.

> 
> Hello Stephane,
> 
> You wrote:
> >I have a lot of files where sub-type must be change from PF38-DTA to
> >PF-DTA. Cpyf and crtdupobj doesn't change the sub-type.
> >Any ideas ?
> 
> Change the DDS source type from PF38 to PF and then run CHGPF 
specifying 
> the DDS source. No real change to the file will occur except the type 
will 
> become PF.
> 
> Regards,
> Simon Coulter.
> --------------------------------------------------------------------
>    FlyByNight Software         AS/400 Technical Specialists       
>                                                                   
>    http://www.flybynight.com.au/                                  
>    Phone: +61 3 9419 0175   Mobile: +61 0411 091 400        /"\   
>    Fax:   +61 3 9419 0175   mailto: shc@xxxxxxxxxxxxxxxxx   \ /   
>                                                              X    
>                  ASCII Ribbon campaign against HTML E-Mail  / \   
> --------------------------------------------------------------------
> 
> _______________________________________________
> This is the Midrange Systems Technical Discussion (MIDRANGE-L) 
mailing list
> To post a message email: MIDRANGE-L@xxxxxxxxxxxx
> To subscribe, unsubscribe, or change list options,
> visit: http://lists.midrange.com/mailman/listinfo/midrange-l
> or email: MIDRANGE-L-request@xxxxxxxxxxxx
> Before posting, please take a moment to review the archives
> at http://archive.midrange.com/midrange-l.
> 
> 

Dave Dunfield
Midwest Integrated Systems Resources
AS/400  and LANSA Expert
PO Box 1481
Portage, MI 49081
 
Phone-269-373-3049 Cell 269-501-5685