Re: Auto dial to off site iSeries after IPL

If he had distributions stacked up would then SNDDSTQ help?

Rob Berendt
-- 
"They that can give up essential liberty to obtain a little temporary 
safety deserve neither liberty nor safety." 
Benjamin Franklin 




"Steve Landess" <steve_landess@xxxxxxxxxxx>
Sent by: midrange-l-bounces@xxxxxxxxxxxx
02/18/2003 12:35 PM
Please respond to Midrange Systems Technical Discussion
 
        To:     "Midrange Systems Technical Discussion" 
<midrange-l@xxxxxxxxxxxx>
        cc: 
        Fax to: 
        Subject:        Re: Auto dial to off site iSeries after IPL


> Randy wrote:
> At this time, I am having to call into the iSeries that was IPL'd and
> doing a STRPASTHR to get the boxes to connect.
>

Randy -

Apparently you have these two lines set up to auto-dial.  Since you can't
use the STRPASTHR command in a batch program like the QSTRUP program, I
believe that you can use the STRMOD command to get communications started
with each of the remote systems.

Example:
STRMOD RMTLOCNAME(LOC1) DEV(*LOC) MODE(*NETATR)
STRMOD RMTLOCNAME(LOC2) DEV(*LOC) MODE(*NETATR)

except use your remote location names instead of  LOC1 and LOC2.  Also, if
you are using specific mode descriptions, you'll need to specify the mode
name instead of *NETATR.

HTH

Steve Landess
Austin, Texas
(512) 423-0935
_______________________________________________
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing 
list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.