Re: V5R1 Upgrade

[Raul A Jager <raul@xxxxxxxxxx>]

The message is bothersome, the AS can be configured with the console at 
0, 0 as the main, but I don't remeber how to do it.

Joe Pluta wrote:

> > From: Andy Nolen-Parkhouse
> >
> > I have found that a machine configured for Operations Console will use a
> > console at Port 0, Address 0 of a twinax controller if the Ops Console is
> > not present.  This is documented in the Hardware Service Functions
> > manual.  The system will assign up to two alternative consoles.
> >    
> Thanks, Andy, that's what I thought.
>
>
>  
> > On my own machine I would probably change the environment to designate
> > twinax as the primary console, but the use of alternative consoles is
> > supported by the hardware.
> >    
> Personally, that would be my choice, too, but I haven't been able to figure
> it how to do it.   I asked the CE the last time he came out (when I threw a
> drive), and he had thought that it would reconfigure itself after the next
> IPL.  It didn't.
>
> Joe
>
> _______________________________________________
> This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
> To post a message email: MIDRANGE-L@midrange.com
> To subscribe, unsubscribe, or change list options,
> visit: http://lists.midrange.com/mailman/listinfo.cgi/midrange-l
> or email: MIDRANGE-L-request@midrange.com
> Before posting, please take a moment to review the archives
> at http://archive.midrange.com/midrange-l.
>