|
Are the controller types different between the two machines? IE one is SPD 6050 and the other is a 2746 PCI controller? If so, the new controllers run at a higher speed than the old ones. This may be causing a communications error if the 4224 does not support the higher twinax line speed. There is a data area you can create to run the newer controllers in compatibility mode. Can't remember what it is but check the archives cause I heard about it here first. Chris Bipes -----Original Message----- From: Jerome Draper [mailto:jdraper@trilosoft.com] None of the below. Rob, The printer was not "moved" except that the twinax was moved from the brick on the V4R2 AS400 to the brick on the V5R1 AS400. The printer was not physically moved. Could it be the brick on the V5R1 AS400 (yes, could be). Paper was not unloaded/reloaded nor was paper thickness changed. NeilP, I'll try your suggestion of moving it to a new port on the brick (perhaps it's the brick). bdietz: No the devices were not migrated and we tried the delete/recreate of the device to no avail. Jerry
As an Amazon Associate we earn from qualifying purchases.
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.