Re: ENDSYS *IMMED vs ENDSBS *ALL *IMMED

Hello Don,

You wrote:
>my more than ample gutt tells me that it was because I dont' recall a
>endsys cmd on the s/38 and most of us old farts learned it back on the
>s/38 or were taught by an old fart that learned it back on a s/38....:)
>Back then we had TRMSBS but no TRMSYS...actually went down to the dungeon
>to check my old pocket guide...from CPF 8.1...:)

But there was a Terminate CPF command.  It doesn't have change bars in my
CPF 8.0 version of the Programming Reference Summary so it must have existed
at least on CPF 7 and probably earlier but that's before my time.

        S/38            AS/400
        -----           --------
        TRMSBS          ENDSBS
        TRMCPF          ENDSYS

There was something so much more satisfying about TERMINATING things rather
than merely ENDing them!  I still think we need a TRMUSR command ...

        TRMUSR  USER(that-annoying-bastard-in-accounts) PREJUDICE(*EXTREME)

Regards,
Simon Coulter.

--------------------------------------------------------------------
   FlyByNight Software         AS/400 Technical Specialists
   http://www.flybynight.com.au/

   Phone: +61 3 9419 0175   Mobile: +61 0411 091 400        /"\
   Fax:   +61 3 9419 0175   mailto: shc@flybynight.com.au   \ /
                                                             X
                 ASCII Ribbon campaign against HTML E-Mail  / \
--------------------------------------------------------------------