RE: Post Ethernet Install Woes - Need Help -- MIDRANGE-L

To set the IPL back to automatic, follow the same steps you took to set it
to Manual, but select just B, not B M (M = Manual).  Foggily remember it
might show B N.  To paraphrase your original instructions:

At the panel go with the arrowkeys to 02 an press enter now press the
arrowkey until you see "02 B" (maybe "02 B N") now press the enterkey, press
arrowkey until 01 is shown then press the enterkey again. Now your maschine
is in normal mode.

-----

Why your ethernet line isn't coming up will take some troubleshooting.
An etherline card has a Controller and a Line.  Vary off the controller.
WRKCFGSTS *CTL  find your controller on the list and make sure it's varied
off.  Now WRKCFGSTS *LIN and find your line and make sure it's varied off.
Now go back and vary on your controller, then go and vary on your line.
That usually does the trick for me.

Also: CHGLINETH for your ethernet line and change Online at IPL (ONLINE) to
*YES.
then CHGCTLNET for your ethernet controller and change Online at IPL
(ONLINE) to *YES.

The most likely reason your line isn't coming up is because your controller
is varied off.

-----

Well, maybe your co-worker isn't a *complete* idiot, but you are right,
using Mochasoft wouldn't effect your ethernet in the least.  I've used
Mochasoft for quite a while in many environments, and it hasn't caused any
problems.


Message: 11
From: "Rosewood" <rosewood@chat.ru>

Well, following my saga ...

We got the ethernet card installed in the as400, created the line
description, varied it on, it varied on, configed an IP address, started
TCPIP and was able to connect a-ok.
(more or less followed
http://www.iseries.ibm.com/tstudio/lan/lanstart.htm)

Well, when we did the install we were told to set the system to manual
mode on the front  "at the panel go with the arrowkeys to 02 an press
enter now press the arrowkey until you see "02 B M" now press the
enterkey, press arrowkey until 01 is shown then press the enterkey
again. Now your maschine is in manual mode."  However, no info on how to
set it back to automatic? Mode.

This Saturday the system goes down automatically for an hour and comes
back up.

For some reason tho, the system did not come back up right.  (I sadly
was not there and my less then apt co-worker was.)  He somehow got the
system back up but god only knows what he did.

Now for some reason when we WRKCFGSTS *LIN and try to Vary on the
"LANLINE" (which is listed) it says VARY ON FAILED.

I am not there but he tells me the connection between the as400 and the
switch is on and okay

Any ideas?  We tried creating a new line description since he tried to
re-create a LANLINE desctiption when it was already there.

Also - WRKHDWRSC *CMN shows CMN02 under the lan adapter and shows it
"OPERATIONAL"

Do we (and how do we) need to set the machine back to automatic?
How can we delete these line descriptions and start anew?
Any other ideas?

We had tried the Mochasoft client and my co-worker is convinced that
using the 'unregistered' software is what caused this.  Someone please
tell me that he is a complete idiot.

Help again - and yet another million x million thanks

(PS - Im about to do this all again tonight - fear)