Re: Model E10 not starting - SRC 2507-0001

[Bob Larkin <blarkin@xxxxxx>]

Do you have a console set to address 0 on port 0 of the 1st twinax block? I
noticed when I unplug the console from our 830, it throws a src code, but I
don't remember what it was

Tom Hanson wrote:

> Hi Philipp,
>
> We used an E10 for many years.  I have a few of the old books.
> I think this is a hardware failure of the muli-function IOP.
>
> Good luck!
>
> Tom Hanson
>
> Philipp Rusch wrote:
> >
> > Hello all,
> >
> > I currently have a problem to get some customers data off the disks
> > to tape (Source code he "forgot" to migrate to the new RISC when his
> > old box died during last week ...)
> > I am trying to revive that E10 just to copy that library to tape
> > but it stops with an SRC 2507-0001, the manuals for that system are
> > gone, my oldest handbook "Problem Isolation Procedures" is of an
> > 9404-400 system, which did not have that 2507 code at all.
> >
> > Anybody knows what that means ? All disks are online, so what ?
> >
> > Regards from germany, Philipp Rusch
>
> _______________________________________________
> This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
> To post a message email: MIDRANGE-L@midrange.com
> To subscribe, unsubscribe, or change list options,
> visit: http://lists.midrange.com/cgi-bin/listinfo/midrange-l
> or email: MIDRANGE-L-request@midrange.com
> Before posting, please take a moment to review the archives
> at http://archive.midrange.com/midrange-l.