RE: power down the system

[neilp@xxxxxxxxxxx]

If you want to "watch" as jobs and subsystems are ended, run ENDSYS *IMMED
from the system console first and check WRKACTJOB.
When the system has ended to a restricted state, then you could do
PWRDWNSYS.

...Neil





"Andy Nolen-Parkhouse" <aparkhouse@mediaone.net>
Sent by: midrange-l-admin@midrange.com
2001/11/05 09:28
Please respond to midrange-l


        To:     <midrange-l@midrange.com>
        cc:
        Subject:        RE: power down the system


Mark,

These variables are controlled by the command parameters.  If you
specify *IMMED, then there is no wait time.  If you specify *CNTRLD,
then the system will wait for the number of seconds specified in the
delay parameter until forcing all jobs closed.  During *IMMED
processing, or when the delay time has been met, then the system value
QPWRDWNLMT will determine how much time the system will wait for those
jobs to end.  I'm not sure what you mean by 'ignore user tasks', can you
clarify?

In most cases, you can't watch much because your interactive session
will end early in the process.  The history log will maintain a clear
record of the ending of the jobs in the system.  I don't recall much in
the way of tasks (processes) ending.

HTH,
Regards,
Andy Nolen-Parkhouse

> -----Original Message-----
> From: midrange-l-admin@midrange.com
[mailto:midrange-l-admin@midrange.com]
> On Behalf Of Mark.Pace@ncgicorp.com
> Sent: Monday, November 05, 2001 9:14 AM
> To: midrange-l@midrange.com
> Subject: power down the system
>
>
> 2 questions about PWRDWNSYS
>
> 1. Is there some sort of profile that you need to setup for this
command.
> Such as how long to wait, or if it should ignore user tasks?
> 2. How can you watch what is happening?   Such as the jobs and
processes
> ending?
>
> Thanks very much!
>
>
>
> Mark D Pace