RE: Break up spool file based on information within (I now know what I am doing!)

They have their own IO for spool files. I am not going to spend hours trying
to figure out their code (the code appears to be computer generated, very
horrible to figure out) and modify it. I would rather spend one or two days
writing this new program, than (pulling out my quite used slingshot)
spending a week slinging code in to this program to see if it will work. If
you have ever worked with Lawson's code, you would understand what I am
talking about. This way I just have to submit the program that will be doing
the splitting and be done with it.

-----Original Message-----
From: Bill [mailto:brobins3d@yahoo.com]
Sent: Thursday, September 13, 2001 3:42 PM
To: midrange-l@midrange.com
Subject: Re: Break up spool file based on information within (I now know
what I am doing!)


You said that it was a purchased product, do you have the program source?
If
so, couldn't you close and reopen the printer file in the original program
every
time you wanted to create a new spool file?

Bill

> Here is what I think I will do:



_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com

_______________________________________________
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@midrange.com
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/cgi-bin/listinfo/midrange-l
or email: MIDRANGE-L-request@midrange.com
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.