Re: Verify Alignment after changing controllers.

["Mike Shaw" <mshaw@xxxxxxxxxxxxxx>]

Mark,

Which option is being taken to the "Verify Alignment" message?  If you use
the "I" option, it will go away.  If "G" is used, it will do exactly what
you are seeing.

Regards,

Mike Shaw

----- Original Message -----
From: <MWalter@hanoverwire.com>
To: <midrange-l@midrange.com>
Sent: Tuesday, July 10, 2001 11:06 AM
Subject: Verify Alignment after changing controllers.


> Hello all,
>
> I've got a funky problem. We have a 5225 model 1 just recently moved from
a
> IBM 5494 using SNA to a Perle 594 controller using IP. The printer prints
> labels. Since the change over, the operator is getting a verify alignment
> message with every label. Does anyone know what might be causing this?
>
> Thank you,
>
> Mark
>
>
>
> Mark Walter
> Sr. Programmer/Analyst
> Hanover Wire Cloth a div of CCX, Inc.
> mwalter@hanoverwire.com
> http://www.hanoverwire.com
> 717.637.3795 Ext.3040
>
> +---
> | This is the Midrange System Mailing List!
> | To submit a new message, send your mail to MIDRANGE-L@midrange.com.
> | To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
> | To unsubscribe from this list send email to
MIDRANGE-L-UNSUB@midrange.com.
> | Questions should be directed to the list owner/operator:
david@midrange.com
> +---

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---