Re: CL problem

["Alexei Pytel" <pytel@xxxxxxxxxx>]

Return values are only allowed in commands used inside CL programs - that
is, cannot be called from command line.
Specify one or more of the following on CRTCMD ALLOW() parameter - *BPGM,
*IPGM, *BMOD, *IMOD.

    Alexei Pytel




                                                                                
                   
                    "Leif Svalgaard"                                            
                   
                    <leif@leif.org>           To:     <MIDRANGE-L@midrange.com> 
                   
                    Sent by:                  cc:                               
                   
                    owner-midrange-l@mi       Subject:     Re: CL problem       
                   
                    drange.com                                                  
                   
                                                                                
                   
                                                                                
                   
                    07/09/2001 06:34 PM                                         
                   
                    Please respond to                                           
                   
                    MIDRANGE-L                                                  
                   
                                                                                
                   
                                                                                
                   



Well, I'm not quite there yet.
The following CMD source was submitted to compilation:

CMD PROMPT('Test return')
      PARM KWD(RETURN) TYPE(*CHAR) LEN(10) RTNVAL(*YES) +
                   PROMPT('return value')

I get the following compilation error: (severity 30)
sev 30, RTNVAL(*YES) only valid in CL programs or REXX procedures

what's going on?
TIA
Leif

----- Original Message -----
From: Leif Svalgaard <leif@leif.org>
To: <MIDRANGE-L@midrange.com>
Sent: Monday, July 09, 2001 11:07 AM
Subject: Re: CL problem


> that it ! thanks Alexei. I knew there was a trick like that, but
> it had just been too long ago I had to use it.
>
> ----- Original Message -----
> From: Alexei Pytel <pytel@us.ibm.com>
> To: <MIDRANGE-L@midrange.com>
> Sent: Monday, July 09, 2001 10:37 AM
> Subject: Re: CL problem
>
>
> >
> > If MYPROG is a CMD, then RESULT parameter should be declared as RTNVAL
> > (*YES).
> > Otherwise changes to parameter will not get to CL program.
> >
> >     Alexei Pytel
> >
> > "The better is the worst enemy of the good"


+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to
MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator:
david@midrange.com
+---




+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---