RE: controlled power down

[Chris Bipes <chris.bipes@xxxxxxxxxxxxxxx>]

First you need to set the system value for the UPS message queue.  Then you must have this message queue allocated.  I have a short program that monitors the UPS message queue, which I called UPSMONITOR.  This program check for the appropriate messages and performs a controlled power down after so much time has elapsed.  I can send you a link if you would like tomorrow.  You can e-mail me privately or on list.

 

Christopher K. Bipes    mailto:ChrisB@Cross-Check.com
Operation & Network Mgr mailto:Chris_Bipes@Yahoo.com
CrossCheck, Inc.        http://www.cross-check.com
6119 State Farm Drive   Phone: 707 586-0551 x 1102
Rohnert Park CA  94928  Fax: 707 586-1884

-----Original Message-----
From: ken shields [mailto:kjs@idirect.com]
Sent: Monday, June 04, 2001 4:38 PM
To: Midrange usersgroup
Subject: controlled power down

Trying to set my 170 to perform an auto pwrdwnsys, 10 
minutes after a power failure. 
Machine has a UPS 
Have set system UPS to 
600, but when I pull the plug, the system re-ipls. 
Any ideas?

--
Best Regards
Ken Shields
 
  +--- | This is the Midrange System Mailing List! | To submit a new message, send your mail to MIDRANGE-L@midrange.com. | To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com. | To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com. | Questions should be directed to the list owner/operator: david@midrange.com +---