RE: Journal receiver problems

["Bob Crothers" <bob2@xxxxxxxxxxxxxx>]

This works fine if no fields at the front of the record changes.  But if
they do?  And if I remember corectly, the only thing at the end of the
record is the data from your record.

So while you wont level check, you'll probably get decimal data errors (if
you are lucky) or worse.

If this is for in-house use, I'd just recompile.  If you have an OSCHANGES
program (with all your changes to print files, etc.), you could put it right
in that and you wouldnt have to worry about it.

If you are an ISV, then you should probably switch to the API's sooner
rather than later.

JMHO,
Bob Crothers

-----Original Message-----
From: owner-midrange-l@midrange.com
[mailto:owner-midrange-l@midrange.com]On Behalf Of ron hawkins
Sent: Tuesday, May 22, 2001 7:33 PM
To: MIDRANGE-L@midrange.com
Subject: RE: Journal receiver problems



<<what about
<<    dspjrn output(*outfile) outfile(qtemp/xxxx)
<<    cpyf  qtemp/xxxx yourfile  fmtopt(*nochk)



Steve,

This is a great idea. I feel so stupid. Very simple (which are usually the
best ideas).

Thanks,
Ron Hawkins

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator:
david@midrange.com
+---

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---