Re: Remote commands

["Patrick Townsend" <patownsend@xxxxxxxxxxxxxx>]

There have been a number of suggestions regarding FTP which will work fine.
You could also use the AS/400 Rexec server if you have an Rexec client on
the NT. I think Denicomp may have one (http://www.denicomp.com).

Patrick
---
IBM AS/400 communications, FTP automation, and eCommerce
software and consulting services.

http://www.patownsend.com

----- Original Message -----
From: "Dave Willenborg" <dwillenborg@jcrob.com>
To: <MIDRANGE-L@midrange.com>
Sent: Friday, March 23, 2001 8:32 AM
Subject: Remote commands


> I have been requested to setup a program that I have not used before and
> need your help.
>
> We have an NT Server and the AS/400 connected to the Ethernet network.
> Based on certain conditions that happen on the NT Server, a procedure
> needs to be run on the AS/400. The NT server does not have Client Access
> Express installed on it.
>
> I want to send a command from the NT server to start the procedure. Where
> do I go to read about doing this or does someone have an example that
> already does this?
>
> Thanks in advance
> Dave Willenborg
> J C Robinson Seed Co
> dwillenborg@jcrob.com
>
> +---
> | This is the Midrange System Mailing List!
> | To submit a new message, send your mail to MIDRANGE-L@midrange.com.
> | To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
> | To unsubscribe from this list send email to
MIDRANGE-L-UNSUB@midrange.com.
> | Questions should be directed to the list owner/operator:
david@midrange.com
> +---

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---