Re: A600 1730 SRC on Panel

[Philipp Rusch <philipp.rusch@xxxxxxxxxxxx>]

Hello Chris,
In the meantime I solved the problem, I had to remove the first 32 MB then
reseat the others without a gap in banks and it works for my customer now.
Load source (two mirrored 1 G drives) is at 52 % utilization with 1031 MB
total size, the other disks are at 48% with 4 x 1GB and 4x 2 GB in a RAID.
Should be enough for 192 MB to dump to ...
Anyway, it didn't work with all modules in there, so the last bank has to be
free.
It's 1x 32 MB and 2x 64 MB now = 160 MB as was stated as the maximum in
the old manual for the FC2130 processor in those days ...

Regards, Philipp Rusch

Chris Bipes schrieb:

> Well I have the same beast here with 2x32MB and 2x64MB for a total of 196MB.
> Been this way for a couple of years.  3.7 to 4.3 to 4.4.  Never had that
> SRC.  Your configuration seems to be correct.  What is you disk utilization
> for the load source?  Do you have at least 196MB avail for a memory dump in
> case of some sort of failure?
>
> Christopher K. Bipes    mailto:ChrisB@Cross-Check.com
> Sr. Programmer/Analyst  mailto:Chris_Bipes@Yahoo.com
> CrossCheck, Inc.        http://www.cross-check.com
> 6119 State Farm Drive   Phone: 707 586-0551 x 1102
> Rohnert Park CA  94928  Fax: 707 586-1884

---SNIP---

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---