RE: PC Support and 5494's

[Eric DeLong <Eric.DeLong@xxxxxxxxxxxxxxxxx>]

     Bob, 
     
     I'm not sure if you ever got this resolved, but my suggestion would 
     be to make sure the proper modes needed by dos pcs are started for 
     the ethernet controllers/devices. 
     
     hth,
     Eric DeLong


______________________________ Reply Separator
_________________________________
Subject: PC Support and 5494's
Author:  "Bob Crothers" <SMTP:bob@cstoneindy.com> at EXCHANGE
Date:    2/26/01 2:38 PM


I have a customer who has a 5494 controller at a remote location.  To 
this, an Extended DOS PC Support device was attached via twinax.  This 
5494 was connected to the AS/400 via Token Ring and working just fine.
     
Then they changed the 5494 to AS/400 connection to Ethernet.  The 
display devices came up, but NOT the PCS device.  They then changed 
back to Token Ring.  And it still will not come up.
     
The router starts just fine.  But we can not start anything else....it 
just hangs.
     
Any ideas?
     
Regards,
Bob Crothers
Cornerstone Communications
http://www.cstoneindy.com
     
     
     
     
     
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com. 
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.

| Questions should be directed to the list owner/operator:
david@midrange.com 
+---
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---