Re: device parity

Maarten,

 You have the proper setup for RAID (Device Parity).  Even though the
first drive is the load source it still participates in the RAID set. 
Just IPL to DST and select 'Start Device Parity' under work with disk
units, and the system will figure this out for you.  Note that you must
be at an ABSOLUTE maximum of 75% disk utilization or the start parity
will fail on your system due to lack of space.  You should be below 60%
or you're going to need more disk soon.

 HTH
   - Larry

"Maarten Vries, de" wrote:
> 
> I have a model 170 with 4 disks and a raid controller.
> Can I use device parity for that system or is that impossible.
> After installing the load source I only have 3 disks left which is not
> enough for device parity
> 
> Maarten
> _________________________________________________________________________
> Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.
> 
> +---
> | This is the Midrange System Mailing List!
> | To submit a new message, send your mail to MIDRANGE-L@midrange.com.
> | To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
> | To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
> | Questions should be directed to the list owner/operator: david@midrange.com
> +---

-- 
Larry Bolhuis
Arbor Solutions, Inc.
(616) 451-2500
(616) 451-2571 -fax
lbolhuis@arbsol.com
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---