Re: Client Access Session/Job Name

[booth@xxxxxxxxxxxx]

I don't know about Versioning levels but the device name for TCPIP is set 
in the session profile right below where you set the System name.  TCP/IP 
doesn't use any of the PC5250 configurations does it?

_______________________
Booth Martin
Booth@MartinVT.com
http://www.MartinVT.com
_______________________




Leo Lefebvre <leo@tug.on.ca>
Sent by: owner-midrange-l@midrange.com
11/24/2000 04:24 PM
Please respond to MIDRANGE-L

 
        To:     Midrange-L <MIDRANGE-L@midrange.com>
        cc: 
        Subject:        Client Accesss Session/Job Name

Hi everybody,

Up to now, getting a virtual device name QPADEVxxxx was not a problem.
Now, I would like to assign specific session name to specific
workstation.

I've tried to change the 'Workstation ID' parameter on the 'Configure
PC5250' panel of CA but with no success. I still get a QPADEVxxxx
session name when I connect to the AS400 using TCP/IP.

When I connect through NS Router, I get the workstationname I assigned
in the configuration steps.

What am I missing? Is it that connecting through TCP/IP, I am at the
mercy of the AS/400?

--

Leo Lefebvre
President
Toronto Users Group for Midrange Systems
Visit our home page at <http://www.tug.on.ca>
Ph: (416) 606-5960   ---   Fx: (416) 495-0100
mailto:leo@tug.on.ca


+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to 
MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: 
david@midrange.com
+---




+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---