V3R2 TCIP/IP question

Thanks for the reply - again - I only have one interface- wanting to change the 
mask only on the one interface I'm running on - will doing so make the box 
apply the update automatically?  I find it hard to believe it could do that 
without reinitializing the interface.

ate: Fri, 6 Oct 2000 09:25:44 -0700 
From: Chris Bipes <chris.bipes@cross-check.com>
Subject: RE: V3R2 TCP/IP question

Nope,  Just add a new TCP/IP address to any of your interfaces and start it.
No re-booting or start/stopping necessary.  This is not WinXX.

Christopher K. Bipes    mailto:ChrisB@Cross-Check.com 
Sr. Programmer/Analyst  mailto:Chris_Bipes@Yahoo.com 
CrossCheck, Inc.        http://www.cross-check.com 
6119 State Farm Drive   Phone: 707 586-0551 x 1102
Rohnert Park CA  94928  Fax: 707 586-1884

If consistency is the hobgoblin of little minds, only geniuses work here.
Karen Herbelin - Readers Digest 3/2000

- -----Original Message-----
From: SCOTT BURGIN [mailto:SBURGIN@usagroup.com] 
Sent: Friday, October 06, 2000 8:50 AM
To: MIDRANGE-L@midrange.com 
Subject: V3R2 TCP/IP question


We are going to readdress the network that our 400 sits on to use a
different subnet mask - actual host address will stay the same.

Anyone know if the machine needs to be physically restarted, do I need to
stop/start the Ip stack - any work at all?



+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---