Re: ReBuild Access Paths

["Avi Hecht" <avi_hecht@xxxxxxxxxxx>]

Hi,

You can use commands EDTRBDAP & EDTRCYAP .

Good luck
Avi
----- Original Message -----
From: "Mike Naughton" <mnaughton@juddwire.com>
To: <midrange-l@midrange.com>
Sent: Tuesday, September 12, 2000 3:38 PM
Subject: ReBuild Access Paths


> Hi everyone,
>
> Is there a way to tell the system to rebuild access paths? We have a test
> library, which contains copies of production data files (physicals and
> logicals). Periodically, we like to refresh the data from the production
> system, and the fastest way seems to be to use our backup tape to restore
> the prodution library into the test library. However, when we back up, we
> don't save access paths, so the restore doesn't put them into the test
> library. I know after the restore is done I can run programs to open the
> files and rebuild the paths that way, but is there a way to rebuild all
> the paths without having to go through this?
>
> TIA for any suggestions,
>
>
> Mike Naughton
> Senior Programmer/Analyst
> Judd Wire, Inc.
> 124 Turnpike Road
> Turners Falls, MA  01376
> 413-863-4357 x444
> mnaughton@juddwire.com
>
>
> +---
> | This is the Midrange System Mailing List!
> | To submit a new message, send your mail to MIDRANGE-L@midrange.com.
> | To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
> | To unsubscribe from this list send email to
MIDRANGE-L-UNSUB@midrange.com.
> | Questions should be directed to the list owner/operator:
david@midrange.com
> +---
>
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---