RE: RE: Rebuild Access Paths

[Chris Bipes <chris.bipes@xxxxxxxxxxxxxxx>]

Check:
 Access path maintenance  . . . .   *IMMED   
   *SAME
   *IMMED
   *REBLD
   *DLY
on your files.  If they are set to *REBLD or *DLY they will not get rebuilt
or updated until you open the files.  Change them to *IMMED and they should
either start rebuilding whilst your executing the CHGLF command or show up
on the EDTRBDAP screen.

Christopher K. Bipes    mailto:ChrisB@Cross-Check.com
Sr. Programmer/Analyst  mailto:Chris_Bipes@Yahoo.com
CrossCheck, Inc.        http://www.cross-check.com
6119 State Farm Drive   Phone: 707 586-0551 x 1102
Rohnert Park CA  94928  Fax: 707 586-1884

If consistency is the hobgoblin of little minds, only geniuses work here.
Karen Herbelin - Readers Digest 3/2000

-----Original Message-----
From: Mike Naughton [mailto:mnaughton@juddwire.com]
Sent: Tuesday, September 12, 2000 7:45 AM
To: MIDRANGE-L@midrange.com
Cc: midrange-l@midrange.com
Subject: Re: RE: Rebuild Access Paths


I have looked at this, but it doesn't seem to take any parms and all I get
is a blank screen with "No access paths to display" message.
Maybe I'm missing something. . . . ?

Mike Naughton

MIDRANGE-L@midrange.com writes:
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---