RE: Re[2]: Netserver not starting after IPL

[Chris Bipes <chris.bipes@xxxxxxxxxxxxxxx>]

Under 4.3 you must start Netserver using the api that has been passed
around.  Under 4.4 it can be configured to start automatically.  You must
make sure you start both qserver and qusrwrk subsystems in your startup
program.

Hey it works for me! 720 @ 4.4

Christopher K. Bipes    mailto:ChrisB@Cross-Check.com
Sr. Programmer/Analyst  mailto:Chris_Bipes@Yahoo.com
CrossCheck, Inc.        http://www.cross-check.com
6119 State Farm Drive   Phone: 707 586-0551 x 1102
Rohnert Park CA  94928  Fax: 707 586-1884

If consistency is the hobgoblin of little minds, only geniuses work here.
Karen Herbelin - Readers Digest 3/2000

-----Original Message-----
From: MarkP@softlanding.com [mailto:MarkP@softlanding.com]
Sent: Tuesday, August 08, 2000 5:33 AM
To: MIDRANGE-L@midrange.com
Subject: Re: Re[2]: Netserver not starting after IPL



Eric,

The URL would seem to indicate that it is a V4R4 tip, and you said you were
on V4R3.  I know the footnote says it will start automatically when QSERVER
is started, but my experience has been that it does not.

Hope this helps.

Mark Phippard
SoftLanding Systems

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---