Re: 3196 Addressing

["Al Barsa, Jr." <barsa2@xxxxxxx>]

At 11:47 AM 7/17/00 -0400, you wrote:
>Hello,
>I have a 3196 A20 I want to add on my system. I need to change the address.
>Upon turning it on, I hold down the space bar, but only come up with a test
>pattern. I've tried Alt-F4, nothing. Can anybody remember how to change the
>address?

I don't know what an A20 is, however I can tell you that 3196 and 3197 
workstations configuration is just a little bit more intuitive that 
Einstein's Theory of Relativity.

Power off.

Power on with space bar pressed.

Press set up which will display the address somewhat in the lower right 
hand corner.

Then press either (I forget, but what do you want from me.  The last time I 
configured one of these things I was sitting under an elephant in an Ark.) 
F23 or F24 to toggle the address from 0 through 6.

When all is correct press set up again.

I don't remember at this point if the workstation will just come up, or if 
you have to power off and on again.

Al




+--------------------------------------------------+
| Please do not send private mail to this address. |
| Private mail should go to barsa@ibm.net.         |
+--------------------------------------------------+

Al Barsa, Jr. - Account for Midrange-L
Barsa Consulting, LLC.  
400 > 390

Phone:          914-251-1234
Fax:            914-251-9406
http://www.barsaconsulting.com
http://www.taatool.com
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---