Re: Cards TWINAX PCI ADAPTER (attachmate)

[Jerome Draper <jdraper@xxxxxxx>]

Confirm that the user id and password are NOT defaulted in the config of
the router so that you will be prompted.  If you do not get prompted for
the userid/password (as I suspect since you are getting the "VxD activated
link failed msg") then you need to appy the 31xupd.exe NSrouter patch which
is available at:

ftp://ftp.netsoft.com/pub/support/pub/patches/portfolio/midrange/31x/

Since you are using CA/400 there may be a more relevant patch on IBM's web
site.  

Be sure to copy the ..\elite\system patches to \windows\system as directed
(cA400 may be different).

Also, be sure you have the following entries in your system.ini file
(start; run; sysedit)

SYSTEM.INI file entry:

1.      Start; Run; SYSEDIT
2.      Make the following device entry in the SYSTEM.INI file under the
[386ehn] section:

        Device=C:\WINDOWS\SYSTEM\VDNSWQ.VXD

3.      Make the following entry in the SYSTEM.INI file under the [386ehn] 
section:

        IBMDefaultTwinax=N




At 09:42 AM 3/16/2000 +0000, you wrote:
>
>
>i verify the system ID and control point names ( the first think ) but it's
>ok. I dont have any msg's in QSYSOPR or QSYSMSG, and i don't have any
>controller created for this device too.
>At the nsrouter event, i have this : VxD activated link failed and the
>diagnostics card said the enable card failed.
>
>thakn's in advanced
>Carlos Almeida
>
>---------------------- Forwarded by Carlos Almeida/QUATRIX on 16-03-2000
>09:35 ---------------------------
>
>
>joberhol@compures.com on 15-03-2000 21:29:35
>
>Please respond to MIDRANGE-L@midrange.com
>
>To:   MIDRANGE-L@midrange.com
>cc:    (bcc: Carlos Almeida/QUATRIX)
>Subject:  Re: Cards TWINAX PCI ADAPTER (attachmate)
>
>
>
>
><*snip>
>>I try to connect one pc with this cards using client access,( v3r1m3 with
>>last service pack)  but i have one problem to this. The connection error
>is
>>Routine error NSCPIC (RT000B)
>>The card is recognized on the windows ,( no conflit) .
>>
><*endsnip>
>
>Jerry was right about the system ID and control point names, but I think
>the Exchange ID is important too.  Check the exchange ID on the controller
>created for the twinaxial devices and make sure they match.
>
>Are there any messages in QSYSOPR or QSYSMSG?
>
>Jim
>
>

Jerry Draper, Trilobyte Software Systems, since 1976
Specializing in connecting PC's, Windows, MAC's, and LAN's to the AS/400
Representing Synapse, Apple, UDS, Nlynx, Perle, Lucent, etc.
(415) 457-3431; (415) 258-1658fax; jdraper@wco.com
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---