Re: Passthru problem

[Mark Lazarus <mlazarus@xxxxxxxx>]

Alexei,

 Are you referring to a WS entry or a job routing entry?  There is a
generic WS entry.  If the latter, what would the routing data be for a
passthru session?

 -mark

At 12:07 PM 11/23/99 -0600, you wrote:
>SNA sense codes:
>
>084B      Requested Resources Not Available:  Resources
>          named in the request, and required to honor it,
>          are not currently available.  It is not known
>          when the resources will be made available.
>
>     6031 Transaction Program Not Available--Retry
>          Allowed:  The FMH-5 Attach command speci-
>          fies a transaction program that the
>          receiver is unable to start.  Either the
>          program is not authorized to run or the
>          resources to run it are not available at
>          this time.  The condition is temporary.
>          The sender is responsible for subsequent
>          retry.  This sense data is sent only in
>          FMH-7.
>-----------------------------------
>084C      Permanent Insufficient Resource:  Receiver
>          cannot act on the request because resources
>          required to honor the request are permanently
>          unavailable.  The sender should not retry imme-
>          diately because the situation is not transient.
>
>     0000 For LU 6.2, Transaction Program Not
>          Available--No Retry:  The FMH-5 Attach
>          command specifies a transaction program
>          that the receiver is unable to start.
>          The condition is not temporary.  The
>          sender should not retry immediately.
>          This sense data is sent only in FMH-7.
>
>          For non-LU 6.2, no additional information
>          is specified.
>
>
>Both point to problems with subsystem configuration -
>no subsystem has routing entry matching incoming request.

>Best regards
>    Alexei Pytel


>At 07:47 AM 11/21/99 -0600, you wrote:
>>> I'm having a problem passing through from Machine A to Machine B.
>>>Machine B to A works fine.  QSYSOPR does not show any msgs either machine.

>>>  The joblog shows a "CPF8911 Communications failure. Session was not
>>> started."  The sense code is either X'084C0000' or X'084B6031'
>depending on which mode I'm using.


+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---