Re: Passthru problem

[pytel@xxxxxxxxxx]

SNA sense codes:

084B      Requested Resources Not Available:  Resources
          named in the request, and required to honor it,
          are not currently available.  It is not known
          when the resources will be made available.

     6031 Transaction Program Not Available--Retry
          Allowed:  The FMH-5 Attach command speci-
          fies a transaction program that the
          receiver is unable to start.  Either the
          program is not authorized to run or the
          resources to run it are not available at
          this time.  The condition is temporary.
          The sender is responsible for subsequent
          retry.  This sense data is sent only in
          FMH-7.
-----------------------------------
084C      Permanent Insufficient Resource:  Receiver
          cannot act on the request because resources
          required to honor the request are permanently
          unavailable.  The sender should not retry imme-
          diately because the situation is not transient.

     0000 For LU 6.2, Transaction Program Not
          Available--No Retry:  The FMH-5 Attach
          command specifies a transaction program
          that the receiver is unable to start.
          The condition is not temporary.  The
          sender should not retry immediately.
          This sense data is sent only in FMH-7.

          For non-LU 6.2, no additional information
          is specified.


Both point to problems with subsystem configuration -
no subsystem has routing entry matching incoming request.

Best regards
    Alexei Pytel


boothm@earth.goddard.edu on 11/23/99 10:48:14 AM

Please respond to MIDRANGE-L@midrange.com

To:   MIDRANGE-L@midrange.com
cc:
Subject:  Re: Passthru problem




QSNADS subsystem is running on both machines?  None of the communications
are varied off?

_______________________
Booth Martin
boothm@earth.goddard.edu
http://www.spy.net/~booth
_______________________




Mark Lazarus <mlazarus@ttec.com>
Sent by: owner-midrange-l@midrange.com
11/22/1999 05:12 PM
Please respond to MIDRANGE-L


        To:     MIDRANGE-L@midrange.com
        cc:
        Subject:        Re: Passthru problem

Nina,

At 07:47 AM 11/21/99 -0600, you wrote:
>> I'm having a problem passing through from Machine A to Machine B.
Machine
>> B to A works fine.  QSYSOPR does not show any msgs either machine.
>>
>>  The joblog shows a "CPF8911 Communications failure. Session was not
>> started."  The sense code is either X'084C0000' or X'084B6031'
depending on
>> which mode I'm using.
>
>just a wild guess, but could qcmn be down on system b?

 No.  There are Rally! sessions running which uses the communications
subsystem.  Any other thoughts?

 -mark

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to
MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator:
david@midrange.com
+---



+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to
MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator:
david@midrange.com
+---



+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---