Re: Ethernet card problems after new OS install

[Jim Langston <jlangston@xxxxxxxxxxxxxxxx>]

I recently installed an Ethernet card in our AS/400 and I had to create
the Line description.  Fairly sure I had to create the controller description
too.  I just followed the book about setting up TCP/IP and all went well.

Regards,

Jim Langston



Jessica Miller wrote:

> Hi Everyone,
>
> I recently did a re-install of 4.3 after initializing the system and 
>everything
> went fine until I went to configure TCP and realized I have no ethernet line
> description, so I had to manually create it. Am I wrong in assuming this card
> should automatically be configured and the line created for it?  I had thought
> that this card would be configured for me and a line created by the os, am I 
>just
> remembering incorrectly?
>
> As always, thanks for the help!
>
> Jessica
>
> +---
> | This is the Midrange System Mailing List!
> | To submit a new message, send your mail to MIDRANGE-L@midrange.com.
> | To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
> | To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
> | Questions should be directed to the list owner/operator: david@midrange.com
> +---

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---