RE: Comparing 2 printouts (before and after) ?

If you've saved the spool files and can sign on more than once, you can do
the same thing by flipping back and forth between the two sessions with the
spool files up on the screen.  This works even for people with my attention
span and level of attention to detail.

I like the "light table" method, though.  That's our standard for testing
form printout on plain paper. 
> -----Original Message-----
> From: jcbradley@voyager.net [mailto:jcbradley@voyager.net]
> Sent: Wednesday, September 15, 1999 6:51 PM
> To: MIDRANGE-L@midrange.com
> Subject: Re: Comparing 2 printouts (before and after) ?
> 
> 
> >I would like suggestions on comparing the outputs of 2 dspfd 
> commands to
> printer performed >on the exact same file before then after a 
> maintenance
> operation.
> 
> Here is the massively parallel optical computing technique 
> first taught to 
> me by Bob A. in Pittsburgh circa 1983:
> 
>     1. Print both listings on greenbar at 10 char/inch.
> 
>        For those of you newer to the profession, that's 
> 14-7/8" X 11" paper 
>        with funny holes along the side.  The cheap stuff is 
> kinda translucent.
> 
>     2. Place one printout on top of the other.
> 
>     3. If your Dilbertanian cubicle is lit like ours were by 
> fluorescents in
> a box 
>        atop the book shelf flipper that worked by reflecting 
> light off of a low 
>        ceiling, climb up on your chair (careful! - it rolls) 
> and use the light 
>        fixture as a light box to illuminate your carefully 
> superimposed
> printouts 
>        from below.  If your's isn't, hold them up against a 
> window (only
> works in 
>        daylight . . . if it's dark out, go home and get a life).
> 
>     4. Mismatched characters will visually stand right out.
> 
> Hey, don't thank me.  Thank Bob!
> 
> Oh, and as I used to tell my kids when they were growing up ...
> 
> Ask me if I'm kidding and if I am, I'll always give you an 
> honest "Yes, I'm
> kidding."
> 
> I'm NOT kidding.
> 
> 
> +---
> | This is the Midrange System Mailing List!
> | To submit a new message, send your mail to MIDRANGE-L@midrange.com.
> | To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
> | To unsubscribe from this list send email to 
> MIDRANGE-L-UNSUB@midrange.com.
> | Questions should be directed to the list owner/operator: 
> david@midrange.com
> +---
> 
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---