Vary on failed

["Moore, Robin M." <rmoore@xxxxxxxxxxxxxxxx>]

 Hi all,
I first wanted to thank you all for the information I have received from 
this
Midrange System Mailing List.

We are running in S36 mode on an as400  V4r3 and from time to time I get
the following message on a device after it had ceased to comunicate(Usually
when power failers or just users closing an open session.

This is a workstation device named Z1 uses an 5250 emulation card.
I can vary the device ( it first showes failed sometimes) , but when I vary
the device on, I get the following message.

Usually atleast by the next day I can vary the device on and it will work.

I have worked with active jobs to make sure the job isnt still running.

Thanks for you help.. Robin

                                                                              

 Message ID . . . . . . :   CPD27CF       Severity . . . . . . . :   40 

 Message type . . . . . :   Diagnostic 

 Date sent  . . . . . . :   08/03/99      Time sent  . . . . . . : 
  10:06:11
                                                                              

 Message . . . . :   Device Z1 vary on failed. 

 Cause . . . . . :   Configuration error was found by the system.  The vary 

   command failed. Reason code 00002006. Reason codes and their meanings 

   follow: 

     --00002006: The device type specified in the device description Z1 does 

   not match the type associated with resource PRT048. 

 Recovery  . . . :   Do one of the following and then try the request again.

    
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---