Re: Message suppression

[pytel@xxxxxxxxxx]

You can specify mesage queue for controller-related messages other than QSYSOPR.
Look for MSGQ parameter on CHGCTLxxx commands.
(It may be not supported for older versions...)

Best regards
    Alexei Pytel



Lurton Keel <Lurton.Keel@SERX.COM> on 06/24/99 11:52:37 AM

Please respond to MIDRANGE-L@midrange.com

To:   "'MIDRANGE-L@midrange.com'" <MIDRANGE-L@midrange.com>
cc:    (bcc: Alexei Pytel/Rochester/IBM)
Subject:  Message suppression





We run Messenger Plus to send pages all over the country to technicians.  We
have 4 modems connected to the pool.

My problem is this:  We get continuous CPF5908 and CPF5909 messages when the
controllers get connected and varied on the lines.  The QSYSOPR message
queue gets filled with thousands of the messages every day so we miss a lot
of other messages that may be significant.

I have asked this before with no workable answer but is there a way so
suppress these messages.  They are informational and severity 00 and they
get issued from program QSWNDSUC from job QSYSARB.

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---



+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---