Re: as/400 to as/400 communications

[Don <dr2@xxxxxxxxxxxx>]

Al,

This brings up a question.  Do you guys have as part of qpatools a util
that will establish/define/crtalldef's needed for a switched point to
point sdlc connection via the ecs modems that will allow for remote dialup
support??


On Thu, 3 Jun 1999, Mike Cunningham wrote:

> I just setup a 3rd AS/400 at our site and can't get passthru to work.  It 
>works fine between the other two but I keep getting a "route to specified 
>location not found" CPF8933.  When we setup our existing 2 AS/400 for passthru 
>I do not remember doing anything special and the current used controller and 
>device descriptions show that they were autocreated.  What do I need to do to 
>get this third system setup with APPN so I can do a STRPASTHR command ?
> 
> +---
> | This is the Midrange System Mailing List!
> | To submit a new message, send your mail to MIDRANGE-L@midrange.com.
> | To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
> | To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
> | Questions should be directed to the list owner/operator: david@midrange.com
> +---
> 

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---