Re: Model 200 problem--how do I get out of trouble?

["Shen Jianjun" <ipacsjj@xxxxxxxxxxxxxxxxx>]

Hi, David

First I think your AS/400 is OK. I can not be sure why your terminal has no
signon. Maybe the status of device description is Vary Off. If your AS/400
has started the TCP/IP protocol, you can log on from the other computer
and you can check the problem. 

If you really want to power down the system. Below is the steps:
       1.   Set the control panel to      01  B M    
                         it means that must at the Manual mode
        2.  Press the white Enter key, it will appers    
                      01 ?   Blinking the cursor
        3.  Press the white Enter key again. Wait about five minutes, then
             power down. That's all.

Wish it will be helpful to you.

Shen Jianjun
 


----------
> From: DAVID BULOG <d2ba@xtra.co.nz>
> To: MIDRANGE-L@midrange.com
> Subject: Model 200 problem--how do I get out of trouble?
> Date: Thursday, May 06, 1999 5:40 PM
> 
> Hi all,
> 
> I have just obtained my 9402-model 200--slight problem is that I have no
> idea how to
> get to manual mode and do a powerdown from the AS/400 panel.
> how did I get myself in this sorry state.
> 
> 1:attached good working 3197 terminal set at address 0(tested just before
> on my trusty E20) into port0 of model 200--made sure of 01 B N(for
normal)
> on AS/400 panel and powered on--when terminal changed from 1/80 to 1/2
with
> system status light bottom left hand corner;
> I assumed all ok-since this is usual during a IPL--went away for 40 min.
> Upon arrival noticed no signon screen-terminal still at 1/2 and system
> status light on,
> AS/400 panel shows normal 01 B so I assume must of IPLed OK.
> Retested 3197 terminal on my E20-all OK  and put back into model 200-no
> change.
> 
> Q1:Any clues as to what is going on?
> 
> Q2:I need to go to manual mode and hit the powerdown button--no idea how
to
> get there--the model200 does not take a key like the E20-it has a uparrow
> button,down arrow button and a enterkey?
> 
> Q3:Aboubt 12months ago I found a usermanual for the model 200 on IBMs
> site--cant remember how I got there--any clues?
> 
> thanks in advance 
> 
> Dave B
> 
> 
> 
> +---
> | This is the Midrange System Mailing List!
> | To submit a new message, send your mail to MIDRANGE-L@midrange.com.
> | To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
> | To unsubscribe from this list send email to
MIDRANGE-L-UNSUB@midrange.com.
> | Questions should be directed to the list owner/operator:
david@midrange.com
> +---
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---