Re: IBM 4224 printer

["Gerald Magnuson" <magnuson@xxxxxxxxxxxxx>]

----- Original Message -----
From: Guzak, Michael <Michael_guzak@goval.com>
To: Midrange List (E-mail) <MIDRANGE-L@midrange.com>
Sent: Thursday, April 29, 1999 3:50 PM
Subject: IBM 4224 printer


> I just acquired an IBM twinax printer that I need to connect to our
AS/400.
> It is a refurbished IBM 4224-102.  It arrived without a technical manual
and
> the operator panel is less than intuitive  Is there anyone out there using
> one of these that can tell me how to set/display the twinax address of
this
> guy?  A search of the IBM site turned up little in the way of
> documentation....  Thanks in advance....



to set the address:
Press Stop.

Press and hold Alternate.  Then press and release Test
until the printer displays 305. Release both keys.

Press and hold Alternate. While still holding Alternate,
press and release 9 until the printer displays the address value
you want. Release both keys.

Press and hold Alternate; then press and release Cancel.
The printer will go through a power-on sequence. Observe the
display to see if the printer displays the new address setting.
If the value of the address you set was 001, the printer will
display A1 during the power-on sequence.



+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---