Hello All,
We just received a IBM 6400 Printer, but it was not twinax ready. Reading the
directions, I had to install the card, and then apply a flash update to the
memory via a PC, with the printer as lpt1, using DOS. It seems to work on the 
PC side, but the directions say I'm suppose to see some sort of status on 
the 6400's LCD screen, which I don't. I also do not see any indication that
activity is happening. After the first try, I powered down, then powered 
on the printer but could not get to a twinax config screen on the LCD to put
in an address.

Anyone have any ideas........................

Thanks,

Mike Lindsay 
CIMServe

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---


This thread ...


Follow On AppleNews
Return to Archive home page | Return to MIDRANGE.COM home page

This mailing list archive is Copyright 1997-2019 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].