Re: Force ENDSBS and/or VARYOFF -- MIDRANGE-L

× The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.

Buck Calabro/commsoft wrote:

>I *think* if you do the ENDSBS first, the lines get freed up so you can
>vary them off.  Do an RTVCFGSTS before you try the vary off to see if the
>jobs are ended or not.

        I know the problem is caused because there are unended jobs in the
subsystems.  I was just (lazily) hoping there was a quick fix without
having to write a new routine to locate and cancel the active jobs and
end the printers.

Thanks
Kat Kruse
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---

This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].

Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.