• Subject: Re: Save breakpoints in Source Debug
  • From: "Simon Coulter" <shc@xxxxxxxxxxxxxxxxx>
  • Date: Sat, 02 Jan 99 01:39:51 +0100

Hello Ravi,

Yes, it is possible.  Read section 2.6 of the Interactive Source Debugger 
manual SC09-1897.

Simon Coulter.

// FlyByNight Software         AS/400 Technical Specialists
// Phone: +61 3 9419 0175      Mobile: +61 0411 091 400
// Fax:   +61 3 9419 0175      E-mail: shc@flybynight.com.au
// Windoze should not be open at Warp speed.
//--- forwarded letter -------------------------------------------------------
> X-Mailer: Mozilla 3.01 (Win95; I)
> Date: Wed, 30 Dec 98 17:31:39 -0600
> From: "Ravi" <ravi@spacestar.com>
> To: MIDRANGE-L@midrange.com
> Reply-To: MIDRANGE-L@midrange.com
> Subject: Save breakpoints in Source Debug

> IS it possible to save the breakpoints set up in ISDB and then invoke
> the same break points in a later session? ISDB creates files QIXALOG,
> QIXAMPF in QTEMP. When breakpoints are added they must be stored in one
> of these files. During the debug session, I don't find any entries in
> these files, and maybe when the program ends the files are cleared out.
> Any ideas??
> Thanks
> Ravi

| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com

This thread ...

Follow On AppleNews
Return to Archive home page | Return to MIDRANGE.COM home page

This mailing list archive is Copyright 1997-2020 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].