Modem configuration -- MIDRANGE-L

× The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.

I am trying to configure an AT&T Dataport 14.4 modem  for synchronous
communications between AS/400s. The manual says the AT &Q1 command will put
the modem in synchronous mode using the AT protocol to dial and AT &Q2 uses
the number stored in directory location 1.(As far as I know the AS/400
doesn't use either method). I tried both settings and the modem doesn't do
anything. 

We are already using an IBM modem on one line and it works fine but we need
more lines. We have several of these modems on hand and I would like to use
them if possible. 

Will this modem work for this?





+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---

This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].

Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.