Re: width of a spoolfile in a cl

["Jeffrey M. Silberberg" <silbrbrg@xxxxxxxxxx>]

 Okay, 

        I'll byte..  The only two ways I know of are the API based on 
your original note, and the PRTDS available in the original program. 

        Sorry, 
        JMS

On Fri, 20 Nov 1998 Kmh0421@aol.com wrote:

> Hello all. A few days ago I inquired about determining the width of a
> spoolfile from within a cl... and did not get not even one reply..... Was my
> question off base? No one had a better way than the API I used? Sorry for the
> re-check... I was just hoping there was something easier....Thanks again, in
> advance....
> +---
> | This is the Midrange System Mailing List!
> | To submit a new message, send your mail to MIDRANGE-L@midrange.com.
> | To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
> | To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
> | Questions should be directed to the list owner/operator: david@midrange.com
> +---
> 
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---