SDLC Help (again)

[Vincent LeVeque <vleveque@xxxxxxxxxxxxx>]

Against better advice, I've purchased an IBM brand SDLC card (used), to
enable dial-in to a local AS/400 through the ECS port.

The SDLC card came with no documentation or configuration software.  I can't
seem to get Windows NT or CA/400 to "see" it.

Any suggestions?  Besides "buy a Hayes Autosync", which I probably should
have done in the first place.

I understand there might be a diagnostic diskette available for this card.
If so, does anyone know where I can get it?



                  |-------------------------------------------------|
                  |               Vincent LeVeque                   |
                  |  Science Applications International Corporation |
                  |   Center for Information Security Technology    |
                  |     222 North Sepulveda Boulevard Suite 1740    |
                  |        El Segundo, California 90245             |
                  |           (310) 615-0117 ext. 12                |
       ==============================================================
      |         Temp Phone at Kaiser Permanente: 626/564-7609        |
      |Temp Fax at Kaiser Permanente: 626/564-7564-call before faxing|
       ==============================================================

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---