Re: A worried New comer with a CUM install.

Pete

At 08:43 PM 5/22/1998 -0500, you wrote:

-snip-

>Not to worry. Since you have already read the instructions through to the
end, making note of any special requirements that may apply to you, and the
dedicated system time requirement (which is usually pretty accurate), and
reviewed the PSP information, you have already completed task 1, although
you may wish to run RCLSTG before doing the apply. Note that RCLSTG also
requires a dedicated system (restricted state), and can take a significant
length of time, which will vary based on processor and the amount of DASD.
Nobody knows how long it will take, but it will be longer if it hasn't been
run for a long time. You are usually safe if you can let it run for 8
hours, it could be done in 2 hours or less. Your mileage will probably vary.

Recently had a conversation with IBM Support LIne about RCLSTG. Was told
that if it does not finish in one run, it's OK. It'll resume where it left
off the next time. We've not done one for some time, but we need to. We
have a 510 with 25G DASD—I anticipate a long run. <g>

Cheers

Vernon Hamberg
Systems Software Programmer
Old Republic National Title Insurance Company
400 Second Avenue South
Minneapolis, MN  55401-2499
(612) 371-1111 x480


+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---